DIY Motorized Engraver

Written by: admin@makezilla

Picture of DIY Motorized Engraver2015-10-20 22.16.46.jpg

Make your very own Hand held motorized engraver with simple household stuff

Step 1: The materials you'll need:

Picture of The materials you'll need:

The materials you'll need are the following

pvc pipe

DC motor

sand grit paper

small metal rod

toothbrush

wires

2pcs. alligator clips

12V voltage source (Variable Voltage Source)

pliers

cutters

Glue stick

lighter

Step 2: Now the Main component:

Picture of Now the Main component:2015-10-20 22.36.10.jpg2015-10-20 22.36.23.jpg2015-10-20 22.36.43.jpg

In order to make the engraver, do the following steps

first: cut off the toothbrush as shown

second: cut off the metal rod into a 1 inch length

third: Scratch the metal rod using a cutter or any means of making the tip rough enough

fourth: Heat the metal rod while using the pliers to hold it and put it gently in the cutoff toothbrush.

and now you have an engraver of your own

Step 3: Now the circuitry:

Picture of Now the circuitry:2015-10-20 22.42.41.jpg2015-10-20 22.43.43.jpg

Take the DC motor and connect the wires and put alligator clips at the end of each wire

attach it into the pvc pipe using glue stick fortify and strengthen it all up.

Step 4: And Now you have it:

Picture of And Now you have it:2015-10-20 22.45.30.jpg2015-10-20 22.45.40.jpg2015-10-20 22.45.54.jpg

Your Very own Motorized engraver

Connect it to a power supply and ready yourself for the engraving.

Step 5: You can engrave anything!

Picture of You can engrave anything!2015-10-20 22.17.27.jpg2015-10-20 22.49.00.jpg2015-10-20 22.49.52.jpg2015-10-20 22.54.25.jpg

You can engrave anything!, from glass, metal, plastic, wood, ceramic, almost anything!... not on cloths though and human skin... in case you want blood in your skin....

well, so much for that Engrave and Enjoy!.

Leave a Reply